10
E-flite BAe Hawk ARF Assembly Manual
11. Use needle-nose pliers to bend the pushrod
wire 90 degrees at the mark made in the previous
step. After making the 90-degree bend, cut the
excess wire off of the pushrod leaving 1/4-inch
(6mm) from the bend in the pushrod.
12. Insert the bend into the hole in the aileron
control horn that is one up from the bottom of the
horn as shown.
13. Use needle-nose pliers to open the pushrod
connector wire enough that it can be fit onto the
pushrod wire.
14. Make sure the hole in the keeper fits onto
the pushrod wire. The keeper should fit close
to the control horn and not be bent when
installed correctly.
15. Use hobby scissors to trim the aileron control
horn servo cover on the lines that are molded into
it. Use medium grit sandpaper to clean up and
rough edges and to round the corners slightly on
the cover.
