EN
Optional Transmitter Setup
Buddy Box Setup
Transmitter Thro Aile
Elev Rudd Gear/
Ch 5
Aux 1 Flight Mode/ Panic Switch
SAFE Flight Modes
Supported
DX4e
N
N
N
N
N
N/A
Default
2 pos Flight Mode
DX5e (2pos)
N
N
N
N
N
N/A
Default
2 pos Flight Mode
DX5e (3pos)
N
N
N
N
N
N/A
Default
3 pos Flight Mode
DX6i
N
N
N
N
R
N
*
(Flap System) Norm
UP Arrow 100
Land
Down Arrow 100
2 pos Flight Mode
DX7
N
N
N
N
N
N
*
(Flap System) Norm
Down
Mid
0
Land
UP 100
(3 pos Aux1 switch–0 & 1 are normal 2 is panic
2 pos Flight Mode
DX7s
N
N
N
N
N
R
*
(Switch Select)
Gear to inhibit, FM to Gear, Flap to inhibit, Trainer to Aux 1
3 pos Flight Mode
DX8
N
N
N
N
N
R
*
(Switch Select)
Gear to inhibit, FM to Gear, Flap to inhibit, Trainer to Aux 1
3 pos Flight Mode
DX10t
N
N
N
N
N
R
*
(Channel Input Config)
Gear is A, Aux1 is R stick
3 pos Flight Mode
DX18
N
N
N
N
N
R
*
(Channel Input Config)
Gear is B, Aux1 is switch i
3 pos Flight Mode
* Refer to your transmitter’s manual for more information about Flap System,
Switch Select or Channel Input Config.
N = Normal R = Reverse
Master Transmitter Master Set Up
Slave Transmitter Slave Set Up
DX4e
Factory Trainer Settings
DX4e
Factory Trainer Settings
DX5e (2pos)
Factory Trainer Settings
DX5e (2pos)
Factory Trainer Settings
DX5e (3pos)
Factory Trainer Settings
DX5e (3pos)
Factory Trainer Settings
DX6i
Factory Trainer Settings
DX6i
Factory Trainer Settings
DX7
Trainer to Normal
DX7
Factory Trainer Settings
DX7s
Activate Programmable Master and insure
channels Thro - Aux 1 are set to slave
DX7s
Factory Trainer Settings
DX8
Activate Programmable Master and insure
channels Thro - Aux 1 are set to slave
DX8
Factory Trainer Settings
DX10t
Activate Programmable Master and insure
channels Thro - Aux 1 are set to slave
DX10t
Factory Trainer Settings
DX18
Activate Programmable Master and insure
channels Thro - Aux 1 are set to slave
DX18
Factory Trainer Settings
Master Transmitter Set Up
Slave Transmitter Set Up
IMPORTANT:
If using the buddy box option for training on a transmitter
other than the included DX5e use these settings for a Master and or Slave
Transmitter. Failure to do so will not allow SAFE technology Flight modes to
work correctly.
IMPORTANT:
If using the buddy box option the transmitter must be configured
using the Transmitter Setup and Buddy Box setup charts.
If using any DSM2/DSMX transmitter other than the included DX5e (3 pos gear
switch) the radio will have to be configured correctly for the SAFE system to
work properly.
• SAFE Flight mode is selected using Channel 5 signal (high, middle, Low)
• Panic mode is selected with Channel 6 signal (high, low)
23
