20
E-flite 4-Site Assembly Manual
21. Once the pushrods are connected to the control
horns, apply a drop of foam-safe CA to the heat
shrink tubing. Apply CA to both the pushrod and
control horn side to secure the tubing to each.
22. Use foam-safe CA to glue the two 1 x 3/32-
inch (2 x 25mm) carbon rods in the slots in the
top and bottom ailerons. Make sure the rods
are parallel and centered with the ailerons when
installed.
23. Connect the 6
7
/
8
-inch (175mm) carbon rod to
the control horn of the upper aileron using a piece
of heat shrink and a soldering iron.
24. Use side cutters to trim the carbon rod to the
proper length. Use a piece of heat shrink and a
soldering iron to make the connection between the
top and bottom ailerons.
25. Apply a drop of foam-safe A to the heat shrink
at both the top and bottom ailerons. Make sure to
apply CA to both the pushrod and control horn.
26. Repeat Steps 22 through 25 to connect the
remaining top and bottom aileron.
27. Remove the tape used to keep the control
surfaces centered at this time.