3
WARNING
l
For residential use only! NOT for commercial use!
Any commercial or public use of this
heater
voids all warranties
, and could cause
injury
.
l
This product is
not intended
to be a
primary heat source.
It is for
supplemental heat only.
l
INDOOR use only!
NEVER
use this heater
outdoors!
Doing so may
result in
electric shock!
l
Risk of
electric shock
!
DO NOT OPEN!
No user-serviceable parts inside!
l
NEVER modify this heater
. Doing so could result in personal
injury
or property
damage.
Modification of this fireplace
completely voids all warranties
.
l
ALWAYS
turn this heater off before unplugging it from the outlet.
l
ALWAYS
disconnect
this unit from the
power
supply
before
performing any assembly or
cleaning, or before relocating the electric fireplace.
l
NEVER
leave this heater unattended.
ALWAYS
unplug this heater when not in use.
l
ALWAYS
store this heater in a dry location.
NEVER
use the fireplace if it has become wet.
l
Place the heater near a wall outlet so an extension cord is not needed. If an extension cord is
needed, the
gauge
of the cord
must be at least 14AWG,
and the
rating must be at least
1875 Watts
.
NEVER
use a
smaller gauge
cord with a
lower rating
. Doing so may result in
fire
or
electric shock
.
l
ONLY
use this heater on a
120V AC 15-Amp grounded circuit
.
NEVER
overload the circuit.
If this heater trips the circuit breaker, unplug all other appliances on the same circuit before the
next use. Avoid plugging other appliances into the same circuit as this heater.
l
NEVER
plug this heater into an outlet that is
old
,
cracked
, or has any
loose wires or
connections
. Plugging this heater into a faulty outlet could result in
electric
arcing
within the
outlet that could cause the
outlet
to
overheat or catch
fire
.
l
ALWAYS
check your heater cord and plug connections with
each use
!
i)
MAKE SURE
the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii)
Heaters draw more current
than small appliances.
Overheating
may occur even if it has
not occurred with the use of other appliances.
iii) During use
check frequently
to see if the
plug outlet or faceplate
is
HOT
!
iv) If the outlet or faceplate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
l
The power cord supplied with the heater has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter
MUST
be used. The adapter
MUST
be
properly grounded
to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
l
SAVE THESE INSTRUCTIONS!
