LOCATING YOUR FIREPLACE
When choosing
a location for your new fireplace, ensure the general instructions are followed. Also, for
best effect install the fireplace out of direct sunlight.
It is safe to set the fireplace insert close to non
-combustibles. DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VA PORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER A
PPLIANCE.
Mantel Installation
Please refer to the detailed instructions that come with the mantel that you purchased.
SPECIFICATIONS
ELECTRICAL CONNECTION
A 15 Amp, 110-1200 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this
appliance. Preferably, the fireplace insert will be on a dedicated circuit as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit
comes standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the
installation to avoid the use of an extension cord. If an extension cord must be used, it must be a
minimum 14 ga, 3 wire with grounding type plug and connector and rated not less than 2025 watts. The
extension cord shall not be more than 20 ft (6 m) in length.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to red
uce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace insert if any part of it has been under water. Immediately call a
qualified service technician to inspect the firebox and replace any part of the electrical syste
m which has
been under water.
SERVICE INSTRUCTIONS
For Your Safety
Service must be performed by a qualified service agency.
Glass Information
Dimensions W x D x H
66.2cm x24.6cm x60.6cm
Net Weight Gross Weight
21 kg / 23.2 kg
Voltage
110-120V~
Frequency
60 Hz
Watts
1500 W
