TRANSCEIVER PROGRAMMING
3-9
April 1999
Part No. 001-8170-100
Parameter
Acceptable Responses
Description
Phone System/Group [1] Any LTR-Net or LTR system/
group that is programmed for
telephone calls (conventional
groups are not allowed)
Programs the telephone system/group that is automatically selected
when the Phone Mode is enabled by pressing FCN SND
(Section 2.7).
Revert (scan mode)
L = Last Selected
T = Temporary
Programs which system/group is selected when the transmitter is
keyed in the scan mode (Section 2.8.7). To program “Last
Received”, see “Receive Delay Timer” parameter above. This
parameter is then ignored, so it can be either “L” or “T”.
Double No Access
Locality Search
Yes, No
“Yes” enables the function that automatically initiates a new local-
ity search if two consecutive “NO ACCS” conditions occur (Sec-
tion 2.14). Cycling power or a successful access resets the counter.
ESN (Electronic Serial
Number)
Not applicable
When data is read from a transceiver, the ESN of the transceiver is
displayed. This number cannot be changed.
[1] These parameters do not apply to the standard model (without telephone keypad).
Table 3-2 LTR-Net System Parameters
The LTR-Net System screen shown above is selected from the Radio Parameters screen shown in Table 3-1. Highlight
the desired LTR-Net system at the bottom or Not Used to create a new system and then press the Enter key (see Section
3.2.3). This screen programs the groups and other information unique to one of the selectable LTR-Net systems.
Parameter
Acceptable Responses
Description
Mode
LTR-Net or LTR (with or with-
out group scan),
Conventional, Unused
Identifies the type of system that is programmed. To change the
system type, go to the Radio Parameters screen (see Table 3-1) and
press F2 with the system highlighted. For information on group
scan, refer to Section 2.8.2.
Alpha Tag (System)
Uppercase A-Z, 0-9, - + * ( ) / Programs the unique 7-character system identification. It is dis-
played by the transceiver if alpha tag display mode is selected
(Section 2.3.2). Otherwise, only the system and group numbers are
displayed.
Table 3-1 Radio Parameters Screen (Continued)
