20
Operating instructions for EE310 Humidity / Temperature Transmitter
5 Operation
5.1
Configuration interface
The transmitter can be used for configuration or calibration via the micro USB configuration
interface. An additional supply is not necessary.
After the USB cable is connected, the transmitter is initialised and the configuration is loaded.
The green status LED flashes and indicates proper operation of the electronics.
Blind cover
USB cable
Fig. 21
Remove the blind cover and plug in the USB cable
PCB
LED 1
LED 2
LED 4
LED 3
Current output
Error LED
error LED on = error category 1
error LED flashes = error category 2
Voltage output
power supply/
main board
Fig. 22
Status LEDs are located at the USB port
5.2 3.5” TFT Colour Display (optional)
The EE310 display includes a data logger and push buttons for full configuration of the device.
Upon start-up of an EE310 with display, the data logger and the configuration menu will be
initialised during the first 5 seconds.
1
2
3
4
5
Chart + data logger
Configuration menu
Status information
Buzzer ON / OFF
Error indication / information
Fig. 23
Display with push buttons
