E.C.A. ARCEUS EK 12 MT ERP UK, User And Installation Manual

Page: 42 / 44

www.centralheating.co.uk
Customer name: Telephone number:
Address:
Boiler make and model:
Boiler serial number:
Commissioned by (PRINT NAME):
Company name: Telephone number:
Company address:
Commissioning date:
To be completedby the customer on receipt of a Building Regula � ons Compliance Cer �fi cate*
Building Regula � ons No �fi ca � on Number (if applicable):
CONTROLS ( � ck the appropriate boxes)
Time and temperature control to
hea � ng
Room thermostat and programmer/ � mer Programmable room thermostat
Op � mum start control Load/weather compensa � on
Time and temperature control to hot waterylinder thermostat and programmer/ � mer Combina � on Boiler
Hea � ng zone valves Fi � ed Not required
Hot water zone valves Fi � ed Not required
Thermosta � c radiator valves Fi � ed Not required
Automa � c bypass to system Fi � ed Not required
Boiler interlock Provided
Electric connec � ons ( fi ll the form)
Voltage supply to the boiler single phase three phase
What is the ra � ng of circuit breaker to the boiler? Amps
Is the boiler supply line protected by an RCD? Yes
What size is the cross sec � on of the power cord of the boiler? mm
²
Have all mains connec � ons been checked for � ghtness? Yes
Has a clamp meter test been carried out to verify the power ra � ng? Yes No
Has the electrical installa � on been tested and cer �fi ed? Yes
The system has been installed and commissioned in accordance with the manufacturer’s instruc � ons Yes
ALL SYSTEMS
The system has been fl ushed and cleaned in accordance with BS7593 and boiler manufacturer's instruc � ons Yes
What system cleaner was used?
What inhibitor was used? Quan � ty litres
Has a primary water system fi lter been installed? Yes No
CENTRAL HEATING MODE measure and record:
Maximum capacity current per phase Amps
Central hea � ng fl ow temperature °C
Central hea � ng return temperature °C
COMBINATION BOILERS ONLY
Is the installa � on in a hard water area (above 200ppm)? Yes No
If yes, and if required by the manufacturer, has a water scale reducer been fi� ed? Yes No
DOMESTIC HOT WATER MODE Measure and Record:
Maximum capacity current per phase Amps
Cold water inlet temperature °C
Hot water has been checked at all outlets Yes Temperature °C
Water fl ow rate I/min
ALL INSTALLATIONS
The hea � ng and hot water system complies with the appropriate Building Regula � ons Yes
The boiler and associated products have been installed and commissioned in accordance with the manufacturer’s instruc � onsYes
The opera � on of the boiler and system controls have been demonstrated to and understood by the customer Yes
The manufacturer’s literature, including Benchmark Checklist and Service Record, has been explained and le � with the customYes
Commissioning Engineer’s Signature
Customer’s Signature
(To con fi rm sa � sfactory demonstra � on and receipt of manufacturer' literature)
*All installations in England and Wales must be to Local Authority Building Control (LABC) either directly or through a
Competent Persons Scheme. A Building Regulations Compliance will then be issued to the customer.
© H eating and H otwater Industry Council ( HH IC )
ELECTRIC
BO I LER SYSTEM COMM I SS I ON I NG CHECKL I ST
Th i s Comm i ss i on i ng Check li st i s to be comp l eted i n f u ll by the competent person who comm i ss i oned the bo il er as a means o f demonstrat i ng
comp li ance w i th the appropr i ate Bu il d i ng Regu l at i ons and then handed to the customer to keep f or f uture re f erence.
Failure to install and commission according to the manufacturer’s instructions and complete this Benchmark Commissioning Checklist will invalidate the
warranty. This does not affect the customer’s statutory rights.
www.centralheating.co.uk
42