Date 2023-04-14
Akku Vision - Manual E-Bike Vision Battery compatible to Bosch* Classic
S.
7
/
9
Index 08
*Bosch is a trademark of the Robert Bosch GmbH
The Charging
The charging outside the pedelec is started by unlocking the lock, that way you can remove the battery as usual and
charge it in your appartement or garage in your presence.
Turn off the drive system and wait until the LEDs of the battery expire. Only now, you unlock the lock with the key
counter-clockwise to the left.
When using the E-Bike Vision charger you are able to charge your battery in or outside the battery.
The drive system must be turned off.
Simply open the cap.
Under the cap, the 4pin connector for the E-Bike Vision charger is located.
Start of charging process with E-Bike Vision charger
1.
Connect the charger to the mains.
2.
Turn on the charger and wait until the green LED flashes slowly.
3.
Make sure that none of the battery LEDs are lighting when it’s not mounted in the eBike.
4.
Now plug in the charging connector of the charger to the battery.
5.
In the charging socket of the battery and in the charging plug of the charger, there are guide slots to prevent
the charging plug to be inserted incorrectly. Please turn the charging plug slightly, when you plug it in the
socket of the battery, until it is in its right position. This manifests itself by a slight snap. Now, the charging
plug can be inserted with light pressure. Please do not try to push the charging plug into the charging socket
with too much force, otherwise you could damage the battery or the charger.
6.
Charging process starts. The LEDs of the battery corresponding to its current state of charge begins to flash.
7.
If the battery is almost fully charged (4 LEDs are lighting and the 5th is flashing), the fan will not start
turning under certain circumstances, because the charger switches immediately into the so-called
constant voltage mode. Within this mode, the power consumption of the charger is that low that the
running of the fan is not necessary.
Furthermore, the fan will also turn off towards the end of charging process, as it is no longer needed in
constant voltage mode.
8.
Do not take remove the HMI during charging process!
Once you remove the HMI of your eBike during charging, the capacity indication LEDs turn off. The
charging process is continued indeed, but even if you install the HMI again, you will not see the capacity
indication LEDs again.
During charging, the capacity is indicated by lighting and flashing of the battery’s LEDs as follows:
LED 1 flashing:
0 – 20 % charged capacity
LED 1 lighting and LED 2 flashing:
21 – 40 % charged capacity
LED 1,2 lighting and LED 3 flashing:
41 – 60 % charged capacity
LED 1,2,3 lighting and LED 4 flashing:
61 – 80 % charged capacity
LED 1,2,3,4 lighting and LED 5 flashing:
81 – 99 % charged capacity
LED 1,2,3,4 and 5 lighting:
100 % charged capacity