Dyson DC 24 ball, User Manual

Page: 8 / 12

ASSEMBLY
Lie the vacuum cleaner flat and push on cleaner head until it clicks. Stand the
vacuum cleaner up straight, insert wand into hose and push into place until it
clicks. Attach tool to the side of the vacuum cleaner.
USING YOUR DYSON VACUUM CLEANER
Press foot pedal and recline handle to use. The stabiliser stand will automatically
lift up. To switch ‘ON’, depress power button in front of handle. After cleaning,
push the vacuum cleaner into an upright position and stabiliser wheels will
automatically drop. Use the carrying handle located above the clear bin
TM
to carry
the vacuum cleaner.
CAUTION:
When returning to the upright position, ensure that the stabiliser wheels are fully •
engaged before releasing the vacuum cleaner.
Do not press the cyclone release button while carrying the vacuum cleaner.
•
PLEASE NOTE:
Fine dust such as plaster or flour should only be vacuumed in very small amounts.
•
Consult your flooring manufacturer’s recommended instructions before vacuuming •
and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating
brushbar is used when vacuuming. If this is the case, we recommend vacuuming
in hard floors mode and consulting with your flooring manufacturer. (Refer to
carpets/hard floors section.)
If used in a garage when car cleaning, care should be taken to wipe the soleplate
•
and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles
which could damage delicate floors.
CARPETS/HARD FLOORS
The brushbar will always default to ‘ON’ (spinning) each time you switch on the
vacuum cleaner and recline it for cleaning. The brushbar will automatically stop if it
becomes obstructed. If the brushbar stops during use, please refer to the ‘Clearing
brushbar obstructions’ section. To switch the brushbar OFF (e.g. for hard floors),
recline the vacuum cleaner and turn it ‘ON’, then press the brushbar ‘ON/Off’
button – the brushbar will stop spinning.
HIGH-REACH CLEANING
CAUTION:
Powerful suction can cause the hose to ‘pull back’ – please take care. •
To avoid personal injury and to prevent the vacuum cleaner from falling when •
cleaning stairs, do not work with the vacuum cleaner above you on the stairs.
To release the wand, press button and lift up. Rotate the wand, open the wand cap •
and clip handle into hose. Tools can be attached to either the hose or wand.
CLEAR BIN
TM
EMPTYING
CAUTION:
Switch ‘Off’ and unplug the vacuum cleaner before emptying the clear bin •
TM
.
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. •
To remove the clear bin
TM
from the vacuum cleaner press the button at rear of
carrying handle. To release the dirt, press the red clear bin
TM
release button.
The British Allergy foundation is a UK national charity with the aim of improving
awareness, prevention and treatment of allergies. The British Allergy foundation
Seal of Approval is a UK registered trademark.
PLEASE NOTE:
Do not use the vacuum cleaner without the clear bin
•
TM
in place.
CLEAR BIN
TM
CLEANING
CAUTION:
Do not immerse the whole cyclone in water or pour water into the cyclones. •
Ensure the clear bin • TM is completely dry before replacing.
PLEASE NOTE:
Do not use detergents, polishes or air fresheners to clean the clear bin
•
TM
.
Do not put the clear bin •
TM
in a dishwasher.
When vacuuming, certain carpets may generate small static charges in the clear •
bin
TM
. These are entirely harmless and are not associated with the mains supply.
To minimise any effect from this, do not put your hand or insert any object into the
clear bin
TM unless you have first emptied it and rinsed it out with cold water.
WASHING YOUR FILTERS
CAUTION:
Switch ‘OFF’ and unplug the vacuum cleaner before removing the filters. •
Ensure filters are completely dry before refitting into the vacuum cleaner. •
PLEASE NOTE:
This machine has two filters, located as shown. It is important to check your
•
filters and wash regularly or as required, according to instructions, to maintain
performance.
The filter in the ball should be rinsed and tapped out until the water runs clean,
•
then tapped out again to ensure all excess water is removed. Please leave to dry
completely for 24 hours.
It is normal for the filter in the ball to turn grey in colour. The filters may require
•
more frequent washing if vacuuming fine dust.
Do not use detergents to clean the filters.
•
Do not put the filters in a dishwasher, washing machine, tumble dryer, oven, •
microwave or near an open flame.
BLOCkAGES
CAUTION:
Switch ‘Off’ and unplug the vacuum cleaner before checking for blockages. •
Please ensure the vacuum cleaner is upright before removing hose or airway •
inspection parts.
Beware of sharp objects when clearing blockages.
•
Refit all parts of the vacuum cleaner securely before using. •
PLEASE NOTE:
Clearing blockages is not covered by your machine’s limited warranty. If any
•
part of your vacuum cleaner becomes blocked, it may overheat and then
automatically shut off. Unplug the vacuum cleaner and leave to cool down. Clear
blockage before restarting.
CLEARING OBSTRUCTIONS
CAUTION:
Switch ‘Off’ and unplug the vacuum cleaner before clearing brushbar •
obstructions. failure to do so could result in personal injury.
If your brushbar is obstructed, it may shut off. If this happens you will need to
•
remove the brushbar as shown and clear any obstructing debris. Refit all parts
securely and press the ‘RESET’ button.
CONFORMITY INFORMATION
A sample of this product has been tested and found to be in conformity with the
following European Directives: 2006/95/EC Low voltage Directive, 2004/108/EC
EMC Directive, 1999/5/EC R&TTE directive, 93/68/EEC CE Marking Directive.
PRODUCT INFORMATION
Product weight 5.5kg, 230 – 240V, 50Hz, maximum power 650W.
Please note: Small details may vary from those shown.
This product is protected by the following intellectual property rights:
PATENT/PATENT APPLICATION NUMBERS:
JP 2004-537336; EP 1361812; AU 744408; EP 1119282; JP 2002-527132;
US 6,519,807; AU 744362; EP 1121043; JP 2002-527131; US 6,572,078;
GB 0326102.1; AU 2002-226556; EP 1370172; JP 2004-528876;
US 6,991,666; AU 2002-225207; EP 1361814; JP 2004-520137; US 7,018,439;
AU 2001-240894; EP 1268076; JP 2003-528704; US 6,835,222;
AU 2002-225232; EP 1361815; JP 3940082; US 6,974,488; AU 2003-283157;
EP 1526796; JP 2006-503607; US 2005-0235454; AU 2003-283159;
EP 1526797; JP 2005-534442; AU 2003-283161; EP 1526798; JP 2006-503608;
AU 2004-294771; EP 1680232; JP 2007-508934; US 2007-0079579;
AU 2005-263889; EP 1768536.
Equivalent patents, registered designs and applications exist in other countries.