background image

1. Remove soleplate

Undo three cross-head screws.

Remove soleplate by lifting from the back, and then
remove brush bar.

If cradle becomes detached from soleplate, align
circular ends of cradle with corresponding holes of
soleplate and slot into place, ensuring that ‘front’
edge of cradle faces the right direction.

3. Centralise belt

2. Line up brush bar

Thread removal

After unplugging the cleaner, carefully remove any
entwined cotton, wool or fluff with scissors. 

NOTE: 

Failure to remove these may result in loss of

performance and possible damage to the machine.

3. Changing the belt 

Replacement belts are available direct from 
Dyson Customer Care (Tel: 01666 827272)

Fit belt over motor
shaft and domed
section of brush bar.

Pull belt taut and
locate brush bar 
in slot.

1

2

1

2

D Y S O N C U S T O M E R C A R E

T E T B U R Y

H I L L

M A L M E S B U R Y

W I L T S H I R E

E N G L A N D

S N 1 6

O R P

1

1

1

2

2

With raised section
on end of brush bar
orientated as
shown, locate brush
bar in slot and
rotate end cap
towards back of
machine until it
comes to a stop.

End cap of brush bar

Raised section

3

Cradle

Soleplate

IMPORTANT

Use only genuine Dyson belts.

Helpline

01666 827272

Facsimile

01666 827298

Contact for all service assistance

3

1

2

Rotate brush bar by 

hand to centralise 

belt before re-fitting 

soleplate to machine.

VERY IMPORTANT

W A R N I N G !

For your own safety please

remember to unplug the machine when not
in use and before carrying out maintenance.

Reviews: