Page | 4-6
SkyView
Airplane Flight Manual Supplement, Rev N,
10/23/2020
Course (OBS) Setting
To set the HSI course (OBS):
1.
Press left knob to enter Knob Function Menu.
2.
Rotate knob to highlight CRS.
3.
Push knob to close menu (menu will also close automatically after 5 seconds). This
assigns CRS to knob, and CRS is shown above knob. The HIS course area on the PFD
is also outlined to show that it is selected.
4.
Rotate knob to adjust CRS setting. While CRS setting is changing, screen area is
highlighted in Cyan to draw attention to it.
The CRS value for each available HSI source is retained when that source is
deselected and will be used when that HSI source is re-selected.
Knob Control Panel
) is an optional panel-mounted module for SkyView. This
control panel has three knobs dedicated to the most common SkyView bug functions
– ALT,
BARO, and HDG/TRK. This module is particularly useful in systems with the SkyView Autopilot
installed because it directly controls the bugs that allow the selection of Altitude (ALT), Heading
(HDG) or Track (TRK), and Barometric Setting (BARO).
Rotating the knob change the value of the associated bug. Pushing and holding the ALT and
HDG/TRK knobs synchronizes the bugs with current values. Pushing and holding the BARO
knob sets the Altimeter to match the GPS altitude, standard pressure if above 18,000 feet, or (if
SV-ADSB-472 is installed), the nearest appropriate METAR station.
Figure 3: Knob Control Panel (horizontal and vertical configurations)
