17-038
www.powercommander.com
2012-2014 Kawasaki KX450F - PCV - 4
6
Unplug the stock Throttle Position Sensor connectors (Fig. D).
This is a 3-pin connector pair located rear of the throttle body. It is accessed
easiest from the right hand side of the bike.
The Figure D picture was taken from the left side of the bike, looking inward
between the frame and the airbox.
FIG.D
7
Plug the PCV wiring harness in-line of the stock TPS connectors (Fig. E).
FIG.E
8
Remove the upper bolt that holds the ignition coil to the frame. Use this bolt to
secure the PCV ground wire with the small ring lug at this same location on the
frame (Fig. F).
9
Reinstall the fuel tank, seat, and the number plate. Make sure the fuel tank
does not pinch the PCV wiring harness when reinstalled securely.
FIG.F
Unplug
PCV
PCV
Stk
Stk
Ground
