7
•
The attachment is only to be used with applicable power
units specified by Dynello.
•
Observe all operating instructions and safety regulations
contained in the manual for the power unit the attachment
is used with.
•
Only use attachment with power unit if you are familiar
with and can operate the power unit.
•
Before use, ensure that the attachment is properly
attached to the power unit.
•
Remove the attachment from the power unit before
making any assembly, adjustments or changing add
-
ons.
Such preventive safety measures reduce the risk of
starting the power unit accidentally.
•
Before use, set rotational speed setting on power unit
to lowest setting (max. 400 RPM).
•
Before use, set torque setting (if possible) on power
unit to lowest setting.
•
Before use, gather the to be winded object in a
collected pile.
Never drag the winded object across the
ground during operation.
•
Inspect the attachment for wear and damage before use.
•
If the attachment is worn or damaged, replace the
damaged parts before using the attachment.
•
Inspect the attachment for loose parts before use.
•
If any parts are loose, tighten the parts before using the
attachment.
•
Do not touch or insert foreign objects in rotating parts of
the attachment, as this may cause risk of injury.
•
During operation, never reach into the winded coil. Keep
hands clear of rotating parts and
always use proper
hand position
during operation.
•
Stop the power unit immediately if the winded object
binds and stops.
The attachment can rotate or break if
overstressed.
•
Release variable speed trigger switch pressure
immediately when the end of the winded object
approaches the attachment to lower winding speed.
•
This tool is intended to be used by a single operator, that
they alone are able to control the winding of the winded
object. If the winded object get stuck or too twisted, the
user must immediately release the variable speed trigger
switch on the power unit to prevent any dangerous
situations.
•
Only use original Dynello add
-
ons that are suitable to this
attachment. Only change add
-
ons on attachment when
attachment is removed from power unit.
ENGLISH
(ORIGINAL INSTRUCTIONS)
