4
Low output MC standard phono
The diagram below shows the available settings for using the P75 in standard
amplifier mode with low output moving coil cartridges.
Not sure what setting to use?
The manufacturer of the cartridge usually publishes recommended loading settings.
If no cartridge information is available, we strongly recommend the default setting of:
100 Ohm, 63dB gain. (As per the jumper position shown below).
Left channel shown, Right channel is identical.
Medium output 1mV MC
Use "Low output MC standard phono" mode above.
Set gain to 56dB by fitting all three jumpers to JB3 & JB4.
Set loading to 470 Ω via JB1 & JB2.
See above for jumper locations.
Additional input capacitance
can be added via JB10 and
JB11.
For MC cartridges this is not
required and will have little
effect.
Set gain via JB3 and JB4.
Adjust loading resistance via
JB1 and JB2.
Fit custom Resistor and Capacitor
loading here.
(remove normal loading jumpers
from JB1 and JB2)
