Dynaudio Xeo 10/20/30
13
12
Connections
and control
elements
Scope of
delivery
This section describes the connections and control elements. Please contact your
Dynaudio Xeo distributor if you have any problems with connection and start-up.
Distributor addresses can be found on the Internet at dynaudio.com.
Elements on the rear panel
The Xeo 10/20/30 set consists of a master and a slave unit. The master unit carries the
audio input interfaces.
Service
Mains socket
Aux In
Line In
R
L
1
Optical In
2
3
4
Left
Right
Neutral
Wall
Corner
Red
Green
Blue
Speaker Position
Zone
II
(master unit only)
I
VOLUME
DIRECT
MUTE
ON
OFF
HUB
1
2
3
4
Line
Line
Opt
Opt
Aux
Coax
USB
A
B
C
1
2 Xeo 10/20/30 speakers
2
2 Xeo 10/20/30 speaker cloth covers
3
1 Xeo 10/20/30 remote control
4
2 power cables (country-specific version, length: 2.5 m)
5
1 stereo cable (RCA – RCA, length: 1.5 m)
(Xeo 10 only)
6
1 optical cable (Toslink – Toslink, length: 1.5 m)
(Xeo 10 only)
7
1 stereo cable mini jack (3.5 mm – 3.5 mm, length: 1.5 m)
(Xeo 10 only)
1 Xeo first time setup manual (quick guide for installation, not shown)
1
2
3
7
6
5
4
A
D
C
E
B
I
II
F
A:
Speaker
position
Sound adjustment (depending on the position of the speakers)
•
Neutral
= with free-standing placement
•
Wall
= if placed near a wall
•
Corner
= if placed in a corner
Speaker placement
•
Left
= left speaker for stereo mode
•
Right
= right speaker for stereo mode
B:
Speaker
ID/Zone
Selection of audio zones:
Speakers assigned to different zones can be
controlled separately via the remote control. The zones are identified as
Red,
Green
, and
Blue
.
C:
Aux In:
To connect an analog audio source to the speaker via mini jack.
Line In
To connect an analog audio source to the speaker via RCA.
D:
Optical In (Toslink):
To connect a digital audio source to the speaker.
E:
USB In
For firmware update only.
F:
Mains socket
To connect the speaker to the mains voltage.
Scope of delivery / Connections and control elements
