Dynaudio OW Series, User Manual

Page: 12 / 14

If you have any concerns over the suitability of the structure to which the brackets and
speakers are to be attached, or doubt in your ability to fix the brackets securely, you should
seek professional advice and help.
Note
The bracket mounting hardware and structure must be able to support at least 20kg.
Screw the bracket ball component into the lower tapped hole on the rear panel of the
speaker as far as it will go. Do not over-tighten. Tighten the lock nut against the speaker
body using a 9/16 in spanner or an adjustable wrench.
If a secondary restraint chain is to be used, screw one of the supplied eyelet components
into the upper tapped hole on the rear panel of the speaker as far as it will go. Do not over-
tighten.
Hold the speaker in position with the mounting bracket ball within the jaws of the
mounting bracket clamp. The assistance of a second person is likely to be required. Now
use the Allen key to tighten the mounting bracket clamp screw until the speaker is held
securely in the desired position. Take care to ensure that the speaker cable is routed
appropriately.
If a secondary restraint is to be used, connect a suitable length of wire cable or chain
between the speaker eyelet and a secure mounting location on the fixed structure.