Before operation
6
Dynaudio Acoustics BM9S
Connecting the subwoofer
Subwoofer inputs
The BM9S provides two different signal inputs:
LFE/Slave IN
This input allows the LFE (Low Frequency Effect) channel to be connected.
The signal is:
•
reproduced by the subwoofer
•
routed to the
Slave OUT
for a second subwoofer to be connected.
The
SUB Lowpass
control has no impact on this input.
SAT/SUB IN
This input allows the connection of a full bandwidth signal.
The signal is:
•
reproduced by the subwoofer,
•
routed to the
SAT/SUB OUT
terminals. Low frequencies are cut-off according to
the
SAT Highpass
setting,
•
routed to the
Slave OUT
for a second subwoofer to be connected. High
frequencies are cut-off according to the
SUB Lowpass
setting.
CAUTION
DAMAGE OF DEVICE DUE TO IMPROPER CONNECTION!
X
Set the mains power switch to OFF before connecting the BM9S.
X
Only switch the subwoofer on (mains power switch to ON) after all connections
and set up steps have been properly completed.
+
+
LFE
Slave
SAT/SUB IN
SAT/SUB OUT
Slave OUT
LFE/Slave IN
Subwoofer
+
SUB
Lowpass
SAT
Highpass
Gain
Phase
Mode
Summary of Contents for BM9S
Page 1: ...BM9S Owners Manual ...
