frequency content from the main speakers. This is accomplished by changing the
Output Filter
switch from <Flat> to <Lowcut 80 Hz>.
Multi-channel sound system
In multi-channel sound systems such as AC-3, AMPEG-2, and DTS, the dedicated subwoofer
(LFE; Low Frequency Effects) output from the surround decoder should be used (Fig. A).
If small loudspeakers are used throughout the surround setup, it is preferable to feed bass
signals from all five surround channels, and the subwoofer channel, to the subwoofer(s). If
multiple Dynaudio subwoofers are to be used, connect them with the Utility Link <Utility
In/Out>. Connect the Utility Link between two subwoofers as shown below. Example: two
subwoofers will act as one big subwoofer with a total of six inputs, three on each. It is very
important that
all
controls and switches are set in the same position on both subwoofers.
Use the three inputs <Left>, <Right>, and <Mono> on the first subwoofer for the respective
Left Front
,
Right Front
, and
Center
channels. On the second subwoofer use the
Left
,
Right
, and
Mono
input for the
Left Rear
,
Right Rear
, and
Subwoofer
channels (Fig. C).
(Fig. C)
Summary of Contents for Audience SUB-20A
Page 1: ...Audience SUB 20A Audience SUB 30A Owner s Manual and Safety Instructions ...
Page 17: ......
Page 19: ...Fax 45 86 52 31 16 ...
