PROBLEM SOLVING
System won't arm/disarm
- Ensure all vehicle doors are closed and ignition switch is off.
- Check whether vehicle's central locking responds to remote control.
- Ensure siren is switched on
- Ensure vehicle does not have a flat battery.
System won't trigger
- Ensure that you have allowed at least 40 seconds after setting the system, before testing.
- If testing boot, ensure boot light comes on only when boot switch is operated; it must not remain on constantly.
The remote fails to operate
- Try your spare remote transmitter.
- Contact the dealer the vehicle was purchased from or vehicle manufacturer.
OVERRIDE
The system can be overridden by means of a Personal Identification Number (PIN). Every unit has its own PIN. This PIN
is issued with every system by means of a credit card sized PIN card. Do not lose this card. Do not leave it in your vehicle.
Do not tell anyone your PIN number. Do store the PIN ca rd in a safe and confidential place. Storing the PIN number in a
secure place in your cell phone is an ideal way to store the number.
OVERRIDE PROCEDURE
1.
Insert the ignition key into the ignition switch and turn to the ON position. The blue or re d status LED mounted on the dash
will glow constantly.
2.
Turn the ignition key back to the ACC position, the status LED will begin to flash slowly. Count the number of flashes for the first
digit in the PIN of the alarm/immobiliser. Return the key to the ON position when the correct number is counted.
3.
Repeat step 2 for the remaining digits in the PIN. When all four digits are entered, the indicators will flash once the system will
then disarm
Please Note “Any digit marked '0', indicates 10 flashes .
NB> If the engine is not started within 40 seconds of over -riding, the alarm/immobiliser will immobilize the engine It is necessary to
enter the PIN each time the engine is turned off and the system has auto immobilized.
WARRANTY
This product is warranted by DYNATRON (NZ) Ltd,
P.O Box.
302-384, North Harbour, Auckland. New Zealand. Subject to the
conditions stated below, to be free from manufacturing defects and faulty material within the warranty period stated below.
CONDITIONS
That the warranty registration has
been
completed in
full at
the time of purchase and / or installation and is produced when
warranty service is sought.
The warranty does not cover general maintenance such as cleaning of bonnet switches, door switches, light switches etc, nor
replacement of consumable items such as pilot lamps or transmitter batteries.
Should a product defect become apparent within the warranty period DYNATRON (NZ) LTD will repair the product free of charge
for parts only. Labour to remove and install the serviced product will be the responsibility of the original installer and their
prescribed labour
Warranty terms and conditions. This is a return to base warranty and should a mobile service be required, a call charge may
apply.
This warranty shall be null and void if
1.
The product has been repaired by any other person other than by an authorized DYNATRON service centre
2.
The product has been altered or tampered with in any way or the serial number altered, defaced or removed
3.
The defect has been caused by negligence by the owner or their agent.
4.
The product has not been operated correctly, installed by an authorized DYNATRON installer or has been subjected to misuse
or undue wear and tear.
5.
The control module is damaged by water.
THE WARRANTY DOES NOT COVER T HE FOLLOWING COSTS.
Transport of the product to and from DYNATRON service centres. Insurance of the product in transit to or from the DYNATRON
service centres. Cost of any service call where the product is found by DYNATRON to be in good working order. Cost of any
unauthorized towage of the vehicle will not be met by DYNATRON NZ LTD.
DISCLAIMER
Dynatron systems have all been tested and approved to Australian and New Zealand Standards and only Dynatron Authorised
Installers have been given the information to install your system correctly to those same standards. Dynatron (NZ) Limited will
accept no liability for any independent installation of this product, its performance or operation. We believe that the responsibility
for a system performing according to published and verifiable standards rests primarily with you as the owner and end user.
But, should you have any concerns about your Dynatron system then please call us at Dynatron direct during working
hour’s toll free on 0800508904 and speak to Customer Services or one of our Technical team– We are here to help and we will
see that you get “Simply the Best InCar Security” for your car.
