SD-BOX INSTRUCTION MANUAL, CODE: DYN 81.01.00
Date: 03/03/2020
Version 00
- 26 -
7. MAINTENANCE
7.1.
GENERAL
No specific maintenance is required, except for periodic checks.
At least every year, a system operation verification test shall be carried out as described in section
“
7.2.
CLEANING
Neither the box nor electrical connections must be cleaned with liquids or items that could affect the
correct functioning of the electrical system.
7.3.
STORAGE CONDITIONS AND USEFUL LIFE
The SD-BOX should be stored in a cool, dry place protected from excessive light. It should never
be exposed to bad weather conditions.
Storage temperature: 5-40ºC
Storage humidity: 15-85%
The SD-BOX must remain clean to be clearly identified.
When placing products or product packaging in layers, the storage height must be according to load
and stability.
The useful life of the component is considered to be at least 20 years and must be replaced when
this time has been reached. The SD-BOX should not be used outside the previously established
ranges or its useful life could be affected. In addition, exposure to environmental conditions other
than those marked during operation has not been considered.
7.4.
INSPECTIONS
Installation and
commissioning
Revision every 3
months
Revision every 12
months
Verification tests
X
X
AUTOCHECK test
X
X
Coil performance
X
Battery charging
X
The SD-BOX performs automatic periodic tests every cycle to check the proper operation of the
SAFETY LINE output safety relays and battery condition and charge.
7.5.
SPARE PARTS
Change every 2 years
Change batteries
X
Contact Dynatech or an authorised distributor to purchase the corresponding spare parts.
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/
Summary of Contents for SD-BOX
Page 2: ......
