Dynapac F 121 C, Operation & Maintenance Manual

Page: 179 / 234

F 5.1 5
F_5
.1_
01_G
B.
fm
5-
1
2
Engine lube-oil system (2)
Checking the oil level
A
In case of correct oil level, the oil is be-
tween the two notches of the dipstick
(A).
A
Check the oil level with a paver finisher
standing on a
flat area!
m If there is too much oil in the engine, the
gaskets and seals may get damaged,
while too little oil can lead to the over-
heating of the oil and the damage of the
engine.
For filling in the oil:
- Remove cap (B).
- Fill in oil until the correct level is
achieved.
- Return cap (B).
- Check the oil level once again using
the dipstick.
Oil change:
A
Change the oil when the engine is at op-
erating temperature.
- Remove the cover cap of the oil drain
port (C) and screw on the hose provid-
ed as an accessory.
- Place the end of the hose in a dish to
catch the oil.
- Open the shutoff valve with a spanner
and let the oil fully drain.
- Shut off the valve, remove the hose
and return the cover cap.
- Fill in the oil of specified quality
through the filling port on the engine
until the oil level rises to the correct
mark of the dipstick (A).
A
B
D
F0112_A1.bmp
C