Dynapac DTR100, Operating Instruction

Page: 98 / 124

8.8.4 Replacing the V-belt
Protective equipment: n Working clothes
n Safety shoes
n Protective gloves
1. Park the machine safely
Ä
Chapter 6.6 „Parking the machine
in secured condition“ on page 68 .
2. Allow the engine to cool down.
3. Unscrew the screws and take off the cover.
4. Loosen four fastening screws (2) on both sides.
5. Insert two prybars between the rubber buffer and the frame.
6. Push the engine carrier back until the V-belt (1) is relieved.
7. Take the V-belt off and replace it.
8. Install the new V-belt.
9. Insert the prybars on the opposite side between the rubber
buffer and the frame.
10. Push the engine carrier forward until the required compres-
sion measurement is reached.
ð
Compression measurement: 10 - 15 mm (0.4 - 0.6 in).
11. Tighten the fastening screws (1).
12. Fasten the cover with screws.
13. Check the V-belt tension again after 25 operating hours,
tighten if necessary.
B-100-0032
Fig. 108
2
1
B-834-0253
Fig. 109
1
B-834-0252
Fig. 110
Maintenance – Annually
DTR100 98