Special instructions
2018-02-08
4812325555EN
103
Special instructions
Standard oil and fluid
recommended
When the roller leaves the plant, its several
systems are filled with oil or fluid indicated on
the item "Symbols and Lubricants", which are
proper for operating in places with temperatures
between 5 F and 104 F (-15°C and 40°C).
The following recommendations are applied for
operations in places with temperatures up to
104 F (40°C).
Highest temperature,
from 122F (50°C).
The engine can work under this temperature
using standard production oil, but for other
components, use the following oils:
Hydraulic system - mineral oil, Shell Tellus T100
or equivalent.
Lowest temperature -
risk of freezing
To prevent the system freezing, make sure that
the system has been drained (sprinkler system,
tank(s), hoses) or that antifreezing solutions
were applied.
Temperatures
The limit temperatures are valid for series
rollers.
The rollers with additional equipment, like noise
level diminution equipment may need special
attention when they are operated in high
temperatures.
High pressure
washing
It is important to keep in mind that the
high pressure water must not be directed
towards the fuel tank caps and the
hydraulic system.
Cover the filling nozzle caps with plastic and
lock them with rubber bands. It prevents the
water to penetrate into the cap vent hole, which
may cause damage on the involved systems
and obstructions in the filters.
Never direct the high pressure water towards
electric and electronic components or on the
display (always keep them covered by covers or
plastic).
Fire extinguisher
If there is fire on the equipment, use a dry fire
extinguisher or ABC class carbon dioxide. It is
also possible to use a CO
2
extinguisher (BE
class).
Roll Over Protective
Structure (ROPS)
NEVER weld or make holes on the ROPS.
NEVER repair a ROPS. Always replace it for a
new one.
