Maintenance - Every 2,000 hours
2018-02-08
4812325555EN
97
Annually (Every 2,000 hours of operation)
Park the roller on a level surface.
When checking and adjusting the machine,
always turn off the engine and make sure the
forward/backward lever is in the neutral
position.
When the engine is off in enclosed places,
make sure there is a good ventilation, to
prevent carbon monoxide poisoning.
Replace the hydraulic oil
Be extremely careful when draining the oil. Use
gloves and protective goggles to prevent the
hot oil getting in contact with the skin, which
can cause burns.
To replace the hydraulic tank oil, follow the instructions below:
1. Park the roller on a level surface and turn off the engine.
2. Use a container with the proper capacity to drain the
hydraulic circuit tank (13.20 gal or 50 liters).
3. Remove the battery cap in front of the wheel rears, on the
left side of the frame. There is a drain cock (1) and a plug
(2) on the right side, inside the frame.
4. Remove the hose connected to the drain plug and remove
the plug from the hose edge, then, open the cock.
5. Drain totally the oil. Fill the plug again with new oil and close
the drain cock.
TAKE CARE OF THE ENVIRONMENT: All the
used oil shall be properly stored for
subsequent disposal. Do not dispose of oil on
the ground, sewage system or other place
which can harm the environment.
Fig. - Battery cap
1. Drain cock
2. Plug
1
2
