Dynapac CA152D, Maintenance Manual

Page: 5 / 35

3 CA152 M152EN3
LUBRICANTS AND SYMBOLS
ENGINE OIL Shell Rimula SAE 15W/40 or equivalent
ambient air temperature API Service CH-4 (CG-4)
-10°C – +50°C (14°F - 122°F)
HYDRAULIC FLUID
ambient air temperature
Shell Tellus Oil TX68 or equivalent
-10°C – +40°C (14°F - 104°F)
ambient air temperature
Shell Tellus Oil T100 or equivalent
above +40°C (above 104°F)
BIODEGRADABLE Shell Naturelle HF-E46
HYDRAULIC FLUID When it leaves the factory, the machine may be filled
with biologically degradable fluid. The same type of
fluid must be used when changing or topping off.
TRANSMISSION OIL
ambient air temperature
Shell Spirax SAE 80W/90, HD API, GL-5
-15°C – +40°C (5°F - 104°F)
ambient air temperature
Shell Spirax HD85W/140 or equivalent
above +40°C (above 104°F)
DRUM OIL
ambient air temperature
Shell Spirax SAE 80W/90, HD API, GL-5
-15°C – +40°C (5°F - 104°F)
ambient air temperature
Shell Spirax HD85W/140 or equivalent
above +40°C (above 104°F)
GREASE SKF LGHB2 (NLGI Class 2) or equivalent for
articulated joint. Shell Retinax LX2 or equivalent
for other lubrication points.
FUEL See the engine manual
COOLANT GlycoShell or equivalent
mixed 50/50 with water Anti-freeze protection down to about -41°C (-42°F).
Always use high-quality lubricants, in the quantities specified. Excess
grease or oil can promote overheating, resulting in premature wear.
When driving in extremely high or low ambient tempe-ratures, other lubricants are
needed. Refer to the chapter entitled “Special Instructions” or contact Dynapac.
Engine, oil level Tire pressure
Engine, oil filter Air filter
Hydraulic fluid tank, level Battery
Hydraulic fluid filter Recycling
Transmission, oil level Fuel filter
Drum, oil level Coolant, level
Oil for lubrication