Installation, Operation and Service Manual
RCEM
© 2012 DynAmp, LLC
Page 48
43756 G
19.) SCAN: The SCAN mode of operation continuously acquires and displays rectifier
data sets at the acquisition scan rate of approximately 4 seconds.
a. START: Command button that initiates the SCAN mode of operation.
b. STOP: Command button that terminates the SCAN mode of operation. of
operation.
20.) DEVICES/LEG: Command button used to enter the number of rectifying
devices/leg.
Note: This command button may not be preset on some RCEM spreadsheets.
21.) ANSI RECTIFIER CIRCUIT: Selection box used to select the appropriate ANSI
Rectifier Circuit Number.
B.6
PROGRAMMING THE NUMER OF DEVICES/LEG
Use the following procedure to program the number or devices/leg:
1. Click on the “DEVICES/LEG” command button.
2. Enter the number of devices/leg into the Input Box.
3. Click on the Input Box “Ok” button. The “Display” and “Calibrate” worksheets will be
configured to the number of devices/leg entered.
4. Click on the Input Box “Cancel” button to exit the command without changing the
number of devices/leg.
B.7
SELECTING THE ANSI RECTIFIER CIRCUIT NUMBER
Use the following procedure to select the ANSI Rectifier Circuit Number:
1. Click on the desired ANSI Rectifier Circuit Number checkbox.
2. The “Waveform Factor:” cell will update to the waveform factor for the selected ANSI
Rectifier Circuit.
3. The “ANSI Rectifier Circuit:” cell will display the selected ANSI Rectifier Circuit Number.
NOTE
If you click on an ANSI Rectifier Circuit Number that is already
selected, the checkmark will disappear. However, the “ANSI Rectifier
Circuit:” cell will continue to display the correct ANSI Rectifier Circuit
Number.
