Installation, Operation and Service Manual
LKAT Plus EMC
© 2018 DynAmp, LLC
Page 28
047331 A
6.3
SPARE PARTS
The following table lists the minimum recommended quantities for spare parts for the LKAT
Plus system. As spares are used, replacements should be ordered. Since continuous
operation of high-current measurement systems is often critical, stocking spare parts should
be given high priority.
Some cable assemblies for the LKAT Plus System include circular connectors. Others use
solder cup connectors assembled with adhesive-lined shrink tubing covering the connector
shell. If connector(s) are severed from the associated cable assembly, field installable
replacement connectors may be purchased. These connectors may also be installed after
routing head interconnection cables in conduit. Over-molded replacement cable assemblies
may be purchased for the power input and output cables. Head cable connector(s) must be
replaced by field installable type(s), or with a new head. Refer to Spare Parts List Table 6.1
The LKAT Plus system Measuring Heads require special repair procedures and materials.
However, the heads are very reliable and should require little or no repair over its service life.
Please refer to the nearest authorized DynAmp , LLC service center for information on
repairs.
Disconnect power to the system before servicing.
Table 6.1
Spare Parts List
DESCRIPTION
ITEM
NO.
RECOMMENDED
QUANTITY
Clamp Assembly, LKAT Plus Mounting (includes 2 plungers)
43750
2 (each)
Plunger, LKAT Plus mounting 10-28 x 1” body, 1/8” hex
43281
2 (each)
Drive
Spare System
Complete System
(Head & Metering Unit calibrated as system)
*
TBD
Metering Unit
**
TBD
Measuring Head
**
TBD
* Item number same as original system head
**Contact DynAmp, LLC