Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
Analyzing!! Please wait a moment……..
Frequency 1 : 480
Frequency 2 : 620
0.25sec on 0.25sec off
usr/config$
Note:
1. Record ring back tone: user can use FXS Line1 to call FXO Line1,
after hearing ring back tone, use this command to detect
frequency of ring back tone.
2. Record disconnect tone: Please read the procedure of recording
disconnect tone file from the web site in application.
3. The value of disconnect tone and ring back tone will not write in
flash automatically. Please use the command in “tone” to write in
the tone table.
The Procedures of recording the disconnect tone
Before you start
A PSTN line which connect with the Line 1 port.
A analog phone connect with the Tel 1 port.
Configure Peer-to-Peer mode.
Please record the disconnect tone just follow the stage as below
1. Please enter the command before you record the disconnect tone
record –tone
2. Make a call from PSTN side into Line 1 port.
3. You will get a greeting when the call enter the gateway.
4. Pease dial the number of the Tel 1 port.
5. The phone will ring if the number you dial is correct.
110