Dynamic DX2-ACU, Installation Manual, Page: 40 / 56

GBK65701 DX2 Compact Remote Modules
Installation Manual Issue 1
8.2.2 User interface
l
Power up the system and verify that the information display is operating correctly and that
there are no faults. For more information on the information display, see
7.1.5 Information dis-
play . For more information on fault indication, see 9 Diagnostics .
l
Verify the battery gauge indicator is operating correctly. For more information on the battery
gauge indicator, see
7.1.6 Battery gauge indicator .
l
Verify the attendant indicator is operating correctly - only if an ACU is part of the system. For
more information on the attendant indicator, see
7.1.7 Attendant indicator .
8.2.3 Mode button
l
Press the mode button (using a combination of short and long presses) to change the drive pro-
file and access accessories (if fitted). For more information on the mode button, see
7.1.4
Mode button .
l
Check that the mode is displayed correctly on the information display.
8.2.4 Joystick
l
Drive the wheelchair in all directions and at all speeds. Ensure that the wheelchair responds to
the drive commands as programmed. For more information on the joystick, see
7.1.1 The joy-
stick .
l
Change the drive profile and drive the wheelchair in all directions and at all speeds. Ensure that
the wheelchair responds to the drive commands as programmed.
l
If accessories are fitted, select an accessory with the mode button and operate the accessory
with the joystick.
8.2.5 Emergency stop
l
Test the emergency stop feature by pressing the power button while driving the wheelchair.
For more information on the emergency stop feature, see
7.1.3 Emergency stop .
Warning :
This procedure can be dangerous. Dynamic Controls recommends the use of a seatbelt to prevent the tester from
slipping out of the seat.
8.2.6 OONAPU
l
Test the OONAPU feature by powering up the wheelchair with the joystick out of the neutral
(centre) position. An OONAPU warning will be displayed and the wheelchair will not drive.
l
Continue the test with the joystick out of the neutral (centre) position for more than five sec-
onds - the OONAPU warning will change to an OONAPU fault.
Note :
Ensure that the DX2-RJM or DX2-RJM-LF is set as the active module for this test.
Ensure that the parameter
Disable OONAPU Faults is set to No .
For more information on the OONAPU feature, see 9.1 OONAPU .
8.2.7 Wake up from sleep mode
l
Test the wake up feature when a system is asleep by one or both of the following:
o
momentarily deflecting the joystick. Note: this is only effective if the remote module wak-
ing the system was the active remote module before the system went to sleep, and the
Page 38 - Test