4.3
Flash Codes
Flash codes indicate the nature of an abnormal condition directly from the DX-GB
Status LED. The table below describes diagnostic information for the DX-GB flash
codes.
Flash Code
Description
Possible Solution(s)
1
DX-GB Module Fault
•
Turn the system Off and then On
again.
•
Check DX BUS connections and
cabling.
2
Accessory or
Temperature Fault
•
Turn the system Off, wait a few
minutes for the system to cool down,
and then turn On again.
•
If the fault re-occurs, consult your
Dynamic Service Centre.
3
Left Motor Fault
•
Check the left motor, connections
and cabling.
4
Right Motor Fault
•
Check the right motor, connections
and cabling.
5
Left Park Brake Fault
•
Check the left park brake,
connections and cabling.
6
Right Park Brake Fault
•
Check the right park brake,
connections and cabling.
7
Low Battery Fault
•
Check the battery connections, fuses,
circuit breakers and cabling.
•
Replace the battery.
8
Over-voltage Fault
•
If this occurs during charging, the
battery charger may be faulty.
•
Check the battery connections, fuses,
circuit breakers and cabling.
9
CANL Fault
•
Check the DX BUS connections and
cabling.
10
CANH or other
Network Fault
•
Check the DX BUS connections and
cabling.
•
Turn the Hazard Lights Off, turn the
system Off, and then turn the system
On again.
GBK64048
: Issue 1 – June 2007
34
