Install Video at
www.DynamicMounting.com/Install
6
6
Attaching Swiveling Hook Plate to Mount (Swivel Version Only)
1.
The Swiveling Hook Plate needs to be attached to the Mount before anything else can be
done. Once you have decided which swivel setting would be the best for you, find the
corresponding Swivel Holes as shown in Figure 6.
2.
The Fasteners for Attaching the Swiveling Hook Plate come assembled on the Right or
Left Pivot, if a different swivel setting is needed, simply remove the bolt.
3.
Once you know the holes that you will use, slide the Swivel Pivot Bolt through the holes
and washers from the top as shown in Figure 7
o
Do it from the top so that even if the nut comes off, the Bolt cannot slide out
because of gravity.
o
Some holes may be tight, if so gently hammer the bolt through.
4.
Tighten the Swivel Pivot Nut down with a 1/2" wrench on the top and bottom until all
the parts are compressed together and the Swivel Hook Plate takes a little effort to turn,
you can adjust this effort after the TV is mounted on the wall.
Figure 6 Swivel Holes
(Top View of Mount)
Adjusting the Swivel Tension (Swivel Version Only)
After everything is mounted to the wall; the TV is hung on the mount; and the
counterbalance and tilt are set, the amount of effort it takes to swivel the TV may need to be
adjusted. You do this by tightening or loosening the Swivel Pivot Nut on the Swivel Pivot
Bolt. Access is easiest when the mount is in an out position. Do NOT over-tighten; if it takes
a lot of force to turn the nut then the pivot is as tight as it can be, if you tighten more you will
start to bend the mount. For all swivel settings, if the TV doesn’t stay in the wanted swivel
position, even after the pivot is tightened, the mount may be tilted too much, adjust tilt nearer
to vertical.
Figure 7, Swivel Bolt
(Side View of Mount)
Attaching TV Hangers to Television
Figure 8, Attaching TV Hangers to TV
