Install Video at
www.DynamicMounting.com/Install
10
10
Attaching the Television to the Mount
After the above steps are finished you are ready to put the television on the mount.
See the Adjusting the Counterbalance section on page 12 for more details. If in doubt, error to the counterbalance supplying too
much force. You can easily adjust force later.
We recommend having someone help putting the TV on the mount.
Figure 12, Attaching the Television
TV Level
The Level of the TV can be fine-tuned after it is put on the
mount.
1.
Figure Out which TV Hanger is on the low side of the TV
2.
Figure 13 shows the parts for Leveling
3.
Loosen the #10 Washer and Screw in the TV Hanger
4.
Move the Level Bolt Down Until Level
5.
Lock Position with the Level Locknut
6.
Tighten #10 Washer and Screw back down
Figure 13, TV Level Fine Tuning
(Detail from Figure 2)
Moving the Television Up and Down
If the counterbalance is set up correctly the TV should be able to be lifted all of the way up into the top/locked position with
reasonable effort. To unlock from this position pull out on the bottom of the television. To get the television all the way to the bottom
position you may need to push down on the television. If the TV pops back up from the desired bottom position, reduce the
counterbalance force. Typically, the force to lift the TV all of the way up is approximately 20-30% of the weight of TV.
Warning! Do Not Let Go of the TV Until the Motion has stopped on its Own.
