Install Video at
www.DynamicMounting.com/Install
1
1
Slim Down and Out Swivel Mount Assembly & Installation Directions
Mounting the Slim Down and Out Swivel Mount correctly takes a lot of thought and a lot of planning. Please read the directions
thoroughly and plan out how the mount would be installed best for your use. Each Setup will be different and these directions cannot
account for every situation. Failure to do so may result in Damage, Injury, or Death. Dynamic Mounting is not responsible for any
damage, injury, or death resulting from improper mounting or use of the Down and Out Swivel Mount.
These instructions are only a guide and the consumer is responsible for correct and secure mounting. The person installing the mount
should be a competent person with experience mounting load bearing assemblies. For any questions or concerns, please contact
Dynamic Mounting at
CAUTION:
This wall mount is intended for use only with the maximum weight of
125 lbs. Use with heavier than the maximum weights indicated may result in instability
causing possible injury.
ATTENTION:
Ce support mural est destiné à être utilisé uniquement avec le poids
maximum de 56.7 kgs. Utiliser avec plus lourds que les poids maximaux indiqués peut
entraîner une instabilité et provoquer des blessures.
Potential Heat Damage:
Dynamic Mounting takes no responsibility for damage caused from the fireplace or other heating
sources to the television, mount, or other accessories. Damage could be done when the mount is down, out, or even up. It is up to the
consumer to take the proper precautions to avoid damage. Electrical equipment can overheat easier than expected. Dynamic Mounting
recommends against having fires in the fireplace whenever there is electrical equipment around.
Note:
Do NOT move more than half of your TV below a mantel located above a fireplace. When mounting the Down and Out
Recess Mount over a fireplace with a mantel, do NOT install the Mount such that more than half of your TV can be moved below the
mantel.
Specifications
Fits most Flat and Curved Televisions 40 inches and larger to 125 lbs. Check television weight and mounting hole pattern for
compatibility with your television
Note for smaller televisions;
the mount may be wider or taller than the television. If this is the case then the mount may be
visible in the top position. See Figure 1
Handles televisions 20 to 125 lbs
Allowable television mounting pattern: 6.7in (170mm) to 15.7in (400mm) wide, up to 20.1in (510mm) high. Works with all
VESA patterns in that range, See Figure 1
Product Dimensions: 22.1 x 23.6 x 3.5 to 4.2 inches. See Figure 1
Product Weight: 28 pounds
Tilts 7 degrees to Vertical in top position
Tilt can be fine-tuned Ve/-1 degree in out through bottom position
FAQ
Where do I mount over a shelf?
See the Above Shelf Mounting, section on page 11.
Mount is really hard to move/actuate.
See the Adjusting the Counterbalance section on page 12.
The TV tilts down in the top position.
See the Setting the Tilt in the Top Position section on page 13.
The TV isn’t level in all positions.
When attaching to the wall, level off of the Hook Plate Edge, NOT the plate that attaches to
the wall, see Figure 8 on page 6.
The TV isn’t level in the out and bottom positions.
The TV’s Center of Gravity needs to be centered on the mount, if the stud
spacing isn’t allowing this to happen the
(sold separately) extends the mounts reach and would probably help.
