10
Operating Instruction & User’s Guide
3
VGA Monitor / LCD Monitor
Rear Panel VGA-OUT
4
Mouse Front
Panel
USB
5
CONFIG SWITCH
Rear Panel NTSC/PAL or VGA/TV Setup
Refer to a further description of CONFIG SWITCH below.
1. The input video type must be either NTSC or PAL; these two types must not be used together.
2. Select the input video format (NTSC/PAL) using the CONFIG switch on the rear side of the product.
3. Select the output monitor type (VGA/TV) using the CONFIG switch on the rear side of the product.
4. CONFIG SWITCH
1) VGA
Mode
Resolution of VGA Monitor is
SXGA (
1280*1024) and CCTV Monitor output is supported.
2) TV
Mode
CCTV Monitor output is supported but No VGA mode.
１
-
５
-
２
Connection of Other Devices
Connect the PTZ controller cable, audio input/output, network, and sensors as shown below.
Connecting Device
DVR Terminal
1
Mike / Speaker
Rear Panel Audio Input / Audio Output
2
LAN Cable
Rear Panel Ethernet
3
PTZ Camera
Rear Panel Terminal Block
4
Sensor / Relay / TTL OUTPUT
Rear Panel Terminal Block)
5
Key controller
Rear Panel Terminal Block
2) Audio Input/Output
Depending on models
[16ch/8ch/4ch]
], each of the models supports [16/8/4] line input and 1 line output.
3) Terminal Block
[Figure 2-3. Terminal Block TB1]
[Figure 2-4. Terminal Block TB1 Description]
Terminal Blocks(TB1, TB2) in the rear of the product are for connections of PTZ / Sensor / Relay / TTL
Connection. Terminal Blocks may not be available depending on the model.