Adjustment order
11
Charge method of battery
Open the battery bay, and range the 8 cells AAA battery
into the battery bay, then close the bay. Before adjustment,
change the reverse switch to the lower position(nor). Open
the transmitter and the receiver, and do the following steps:
1.check every servo’s movement and make sure every movement
of control arms and servo arms is correct if not, please change the switch for reverse.
2.check the centering position of aileron, elevator and rudder
open the transmitter rand connect the power to motor. Make sure every servo is in centering position
and check servo arm has a 90 angel with servo. Adjust the length of control rod, and check all control
arm is in neutral position.
3.adjustment for range
check the movement range and the centering position of each servo. If the traveling range is not
accepted, that can be adjusted by the position of clevis on the servo arm.
4.check the connection of esc and motor.
Check the joystick for throttle movement is in accordance with motor. If not, it is can be adjusted
by reverse switch.
5.check the tiny mix for every control horn.
Charge method:
1.turn off the transmitter, connect the transmitter with the charger in kits
(note: please make sure the transmitter be off before charging, it will not charged unless it is off )
2.check it the input voltage is same as the main voltage,
the plug the charger into the socket.
3.the charging time should be no more than 5 hours,
it should be recharged if it has been unused
in long time.
Remark:
1.only the 9.6v Ni-he rechargeable battery can be charged, the dry cell should not be charged.
2.order to prolong the life of battery, please do not charge more than the required time.