Wiring
Sensor
L
N
L
N
Sensor On-off/dimming setting options
（
For code V290 18 SOF/ V290 18 SDM/ V290 18 STM)
Hol d-t i me
5s ~30mi n
Detection area can be reduced by selecting the
combination on the DIP switches to fit precisely for
each specific application.
Detection area
I –
100%
I I – 50%
1
I
II
50%
100 %
Hold-time means the time period you would like to
keep the lamp on 100% after the person has left the
detection area.
I – 5s
I I – 30s
I II – 3min
I V – 10min
30s
5s
10min
3
2
I
II
III
IV
3min
I – Disable
I I –
50Lu x
I II – 10Lu x
I V – 2Lux
Daylight sensor
The daylight threshold can be set on DIP switches,
to fit for particular application.
5
4
50Lux
10Lux
2 Lux
Disabl
e
I
II
III
IV
I –
10%
I I – 30%
8
I
II
30%
10%
This is the dimmed low light output level you would
like to have after the hold-time in the absence of
people.
Stand-by dimming level
Hold-time
2~50L ux
St and- by per iod
0s ~+ 8
I – 0s
II – 3 0s
I II – 10m in
I V – + ∞
This is the time period you would like to keep at the
low light output level before it is completely switched
off in the long absence of people.
Stand-by period (corridor function)
30s
0s
+∞
7
6
I
II
III
IV
10min
Note: “0s” means on/off control;
“+ ” means bi-level dimming control, fixture
never switches off.
8
5m
8m
1.Do like (6-1),knock out the entrance from the
cover and cut off by outline
2.One-to-one correspondence between the position
of the knock out hole of the cover and the position of
the base, then do like (6-2) lock the screws
3.Open the power grid.
1.Fit the diffuser to the
base and lock the screws
2.Open the power grid.
1
.
Fix the cover on the buckle
of the chassis
2.The cable goes from the
bottom of the fixture, follow
the (5) do finish the next step
3.The cable goes from the side
of the fixture, follow the (6-1)
(6-2)do finish the next step.
Detection Pattern
ceiling mounting pattern (m)
5m
8m
wall mounting pattern (m)
9m
4m
Caution:
1. Cut off the main power first
2. Don’t touch LEDs while maintaining or cleaning
3. Don't use chemicals to clean the fixture.
Environmental protection: waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.
Maintenance
RoHS
IK10
IP65
SAA
TM
1. The product must be installed by professional technicians and power supply must be cut off before installation.
2. The diameter for AC input wire is 0.75mm² (complying with 60245 IEC57), which complies with the latest IEE
electrical standards or national standards.
3. Do not touch the electronic circuit and its components.
4. Contact an authorised technical service centre for any repairs possibly required use only original spare parts.
5. Do not touch LED while installing or maintaining.
6. After installation, remember to seal the entrance hole with glue.
.
7. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a
similar qualified person.
