Dynabrade Wet Dynafile II, Operating Instructions

Page: 4 / 4

95604 Motor Tune-Up Kit:
•
Includes assorted parts to help maintain
motor in tip-top shape.
Optional Accessories
DYNABRADE
®
DYNABRADE, INC., 8989 Sheridan Drive • Clarence, NY 14031-1490 • Phone: (716) 631-0100 • Fax: 716-631-2073 • International Fax: 716-631-2524
DYNABRADE EUROPE S.àr.l., Zone Artisanale • L-5485 Wormeldange—Haut, Luxembourg • Telephone: 352 76 84 94 • Fax: 352 76 84 95
© DYNABRADE, INC., 1997 PRINTED IN USA PD97.99_rev.1_03/97
Visit our new Web Site via Industry.Net MROP On-Line: http://www.dynabrade.industry.net E-Mail: DynaTalk@aol.com
Arm Wheel Wheel Wheel Belt Shaft
Number Description Assy. Description Number Size Number
42642 3/4" Wide Platen 42652 3/4" Dia. x 5/8" W rubber 11281 3/4" x 18" / 5/8" x 18" 11285
42644 1/2" Wide Platen 42653 3/4" Dia. x 5/8" W rubber 11077 3/4" x 18" / 5/8" x 18" 11054
42646 No Platen - Offset design 42654 1" Dia. x 3/8" W radiused rubber 11079 1/2" x 18" / 1/4" x 18" 11054
42650 1/2" Wide Platen 42653 3/4" Dia. x 5/8" W rubber 11077 1/2" x 18" 11054
Specialized Contact Arms
Wet Dynafile ®
II
Contact Arm Assemblies
Contact Wheel Assembly – Includes wheel, bearing and shaft.
Contact Arm
Shaft
Bearing
Contact Wheel
Bearing
Abrasive Belt/Contact Arm Change Instructions:
To Change Belt:
1.
Disconnect power source.
2. Remove “pop-off” cover.
3. Pull back on tension arm assembly.
4. Remove and replace abrasive belt and cover.
5. Connect power source.
6. Adjust belt tracking by turning 95218 Rough Adjustment Knob to the left or right accordingly while machine is running.
To Change Contact Arm Assembly:
1.
Disconnect power source.
2. Remove “pop-off” cover.
3. Pull back on tension arm assembly and remove abrasive belt.
4. Remove 95218 Rough Adjustment Knob.
5. Remove contact arm and replace with desired arm, making sure that the tab on the end of the arm is facing downward.
6. Replace 95218 Knob.
7. Install abrasive belt and cover.
8. Connect power source and adjust belt tracking by turning 95218 Knob to the left or right accordingly while machine is running.
Housing Angle Adjustment:
To pivot housing, loosen 95311 Screw on housing with the supplied 9/64" hex wrench (P/N – 95134 ). Pivot housing to desired angle and retighten 95311 Screw.