NITROZIP WIRE WHEEL MOUNTING, CARE AND OPERATION INSTRUCTIONS
GRINDSTONE
Sharpening of Wire Wheel
After using Wire Wheels for a certain period of time the tips of the bristles become round and the “brushing” effect is
reduced. To recover the Wire Wheel performance on the Coarse or Medium brush, simply run the brushes in REVERSE
DIRECTION on stone or concrete flooring for 10-20 seconds. To do this,
DISCONNECT TOOL FROM THE AIR SUPPLY
,
then assemble the Wire Wheel upside down to provide reverse spinning to the brush. Reconnect the tool to air supply and
spin the brush on the grinding stone applying light pressure. Then assemble the Wire Wheel in the correct spinning direction
again. For Fine and straight brushes just REVERSE THE DIRECTION of the brush. No sharpening is necessary.
Rotation
IMPORTANT: READ OPERATORS MANUAL IN ENTIRETY BEFORE USING THE NITROZIP TOOL AND ACCESSORIES.
Wire Wheel Mounting Instructions:
1.
Disconnect the tool from the air supply.
2.
Install the hex socket side of the hub so that it fits onto the male hex portion of the
55817
Spindle.
3.
Install the accessory. Orient the medium and coarse wire wheels so that the ends of the wires point in the direction of rotation.
4.
Install the second half of the hub. (Ensure the 3 pockets line up with the 3 tabs of the 1st half of the hub.)
5.
Hold the hub and accessory stationary and install the star washer along with the socket head cap screw.
Active Rotation
Special Uses
Do Not bear down excessively
Correct Working Positions
•
Wire Wheels work efficiently with minimum force applied to the wheel.
•
The Wire Wheel will be effected if too muchpressure is used. Trying to compensate for decreased efficiency
by applying more pressure will only result in bent, dull and lost needles.
•
If wheel is fatigued, resharpen the bristles using the method mentioned on next page. This will place bristles
back into the proper position and give a sharp point to the bristles.
NitroZip Wire Wheel Recommendations:
NITROZIP ERASER DECAL REMOVAL WHEEL MOUNTING,
CARE AND OPERATING INSTRUCTIONS
Eraser Decal Removal Wheel:
(Decal and Pinstripe Removal Wheel - Max RPM 3,500)
•
The rubber Eraser Decal Removal Wheel is available to remove pinstriping, stickers, decals, adhesive tapes and glue
from metal, glass, fiberglass and wood surfaces without damaging the sub-surface.
When using Eraser Decal Removal Wheel , work INWARD from the edge and from side to side.
Never tilt or move forward & backwards across a solid surface.
•
The notched wheel vents and cools surface.
•
No jumping, No vibration. Easy to handle.
SPECIAL OPERATING INSTRUCTIONS
Never run the tool unless the accessory is applied to the workpiece.
92240 Beige
Eraser Wheel
92255 Red-Tred
®
Eraser Wheel
Eraser Decal Removal Wheel Mounting Instructions:
1.
Disconnect the tool from the air supply.
2.
Install the hex socket side of the hub so that it fits onto the male hex portion of the
55817
Spindle.
3.
Install the eraser wheel. Firmly press eraser wheel onto hub until 3 tabs are visible.
4.
Hold the hub and accessory stationary and install the star washer along with the socket head cap screw.
Note:
The eraser fits loosely between the hub halves.
3
