W E T D E B U R R I N G S TAT I O N : M A I N T E N A N C E
7
MAINTENANCE INSTRUCTIONS
1. Before beginning maintenance on the 21" Metalworking Station, you
must first unplug the GFI outlet from your main power source.
Continue by unplugging any accessory and remove the work surface
from the assembly. Also make sure to turn the reservoir valve to the
“OFF” position.
2. Remove and set aside the upper access panel by loosening all four
lock down knobs a full 2-3 full turns. Continue by turning the release
cam and remove the filter access panel. Remove the filter and hose
clean to remove any built up debris.
3. Now remove the float assembly by loosening the lock down knob.
The float assembly should remain attached to all hose and just rest
assembly over the tools edge as shown below. This should give you
clear access to the main tank.
4. Making sure clean out valve is in the “OFF” position, remove the cap
from the assembly. The valve provided hooks up to a female garden
hose for ease of clean out. Turn valve lever to the “ON” position and
drain tank. Remove the sludge and remainder of water from the
bottom of the tank, making sure not to damage the acrylic tank while
doing so. When tank is clean, turn valve back to the "off" position and
re-cap assembly.
Re-assemble tool and refer to set-up instructions before operating the tool.
(2)
UPPER ACCESS PANEL
FILTER ACCESS PANEL
RELEASE KNOB
FILTER ACCESS PANEL
UPPER ACCESS PANEL
LOCK DOWN KNOB
(Four knobs total)
(1)
WORK SURFACE REMOVED
(2)
FILTER
SLUDGE AT BOTTOM
OF TANK TO BE
REMOVED AFTER
WATER IS DRAINED
(4)
CLEAN OUT VALVE
(Shown in "ON" Position)
(4)
VALVE CAP
(3)
FLOAT ASSEMBLY
MOVED FOR CLEANING
MAIN TANK
FLOAT ASSEMBLY
LOCKING KNOB
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
