NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING
!
10
4
. Remove 4 wing nuts with flat
blade screw driver.
6
. Hold the wick assembly up-side-
down, using caution, grasp the
wick cover firmly PULL it off with a
sharp tug. If you have difficulty
doing so, try loosening the wick
cover with a flat blade screwdriver.
CAUTION : The inside of wick cover
has sharp teeth. The use of work
gloves is suggested to avoid injury.
Wick cover
Pin
Hole
5
. Lift the wick adjuster assembly
straight up and away from the
heater.
10
. Line up the pins with the slotted holes inside the
wick adjuster. then of the wick (now attached to
the wick sleeve) toward the inside insert the
three pins into the slanted grooves of the wick
adjuster. Press on each of the three pins,
inserting them securely in the holes.
11
. 1) Turn the wick adjustment knob to the fully raised
position.
2) Pull lightly on the skirt of the wick to remove any
slack.
3) Press lightly to secure the skirt to the retaining and
remove any slack.
4) You will need to hold the knob to keep the wick at
the highest position.
7
. Remove the wick by folding it to
the inside. Then remove the wick
sleeve from the bottom of the
assembly
9
. Push the new wick into the
retainer teeth of the wick sleeve
so that the wick adheres tightly
around the inside ot the wick
sleeve, smoothing out any
wrinkles.
8
. Install the new wick and insert
the 3 pins on a new wick into
the 3 holes on the wick sleeve
in the upward direction. (See
the arrow marked “up” on the
wick sleeve)
UP
