USE R GUI DE
|
UVC -5 CO NVE Y OR
14
•
Push the UV bulb slightly to the right, press the
left end upwards and remove the bulb (4). Only
touch the ends of the lamp (wear cotton gloves).
Figure 11.
Removing the lamp
•
The installation of the UV bulb takes place in
reverse order. Make sure that the fusion point
in the middle of the bulb points in the radiation
direction.
•
After having inserted the bulb, clean it using the
cleaning cloth included in the delivery.
•
When closing the reflector cover, make sure
that both pins located on the bottom side of the
reflector are inserted in the oblong holes in the
reflector case provided for this.
Do not dump in your normal waste
Do not touch the new bulbs with your
bare hands. Wear cotton gloves!
Only touch the ends of the bulbs. After
installation, the glass surface should
generally be wiped clean using the
cleaning cloth included in the delivery (it
is also possible to clean the bulb with
alcohol or spirit and a clean cloth).
6.2 Disposal of the UV bulbs
Do not dump in your normal waste.
The UV bulbs used by Dymax Europe
GmbH are products according to the
German Electrical and Electronic
Equipment Act and can be disposed of.
The end user is authorized to dispose of
the parts at the local collection point or
recycling center since Dymax Europe
GmbH and its suppliers are registered
with the foundation Elektro-Altgeräte-
Register (EAR).
6.3 Cleaning
Depending on the installation site, it is necessary to
clean the lamp case every 6 months.
Remove dust deposits from the fan and case. It is
important to check the air outlets frequently and
clean, if necessary. Clean the lamp reflector using a
lint-free cloth. Contamination on the reflector
surface can be removed with alcohol. The roller
bearings should be lubricated using a heat-resistant
grease (approx. 100°C).
