19
UVCS LED Light-Curing Conveyor Systems User Guide
LED System Height Adjustment
The conveyor system uses a simple height management structure using a specially designed cradle and
carriage system for ease of height adjustment. The main parts are shown below.
Figure 29. Height Management Structure
Adjustment
1.
For single BlueWave® AX-550 configurations, support the cradle with the handles prior to loosening
the locking levers. For two and four BlueWave® AX-550 configurations, the cradle is supported by
struts to counter the weight and will not require support.
2.
To adjust the height, loosen the locking levers on both sides of the riser and on both risers. This will
allow the carriage to slide up and down the riser to the desired heights.
3.
Clearance heights that are critical should be set using a measuring device or gauge inside the
conveyor to ensure parts will not hit the inner tunnel.
4.
Lift or press down on the handles to move the cradle up and down. Note that the struts will lift the
cradle up on some configurations.
5.
Level the heights of both sides of the cradle and tighten the locking levers on both risers firmly to
ensure proper support and unit is locked in place.
6.
Remove any measuring devices or gauges prior to starting the system.
7.
Verify height setting and clearances prior to starting processes.
Carriage with Locking Levers
Riser
Lift Handle
Cradle
