21
Dymax Edge-Carry Conveyor User Guide
Figure 42. Empty Lamp Cradle
Figure 43. Install Spacers & RF
Dector Support
Figure 44. Install Lamps
Single Fusion Lamp Configuration
▪
Remove any Lamp Cradle Spacers. Relocate the Center Divider Plate. Install the Fusion Lamp Brackets
and the RF Detector Support (Figure 46).
▪
Install the RF Detector, the Fusion Lamps, and Power Supplies as described in the Setup and Interconnect
Section (Figure 47).
▪
Adjust the speed of the Exhaust Blower by setting the Speed Control Knob as described in the Conveyor
Operation Section of this user guide.
Figure 45. Empty Lamp Cradle
Figure 46. Lamp Brackets & RF
Dectector Support
Figure 47. Install Lamps