USE R GUI DE
|
BL UE WAVE
®
A X -5 5 0
9
Figure 9.
Insert Hard Wire into Terminal Block
Figure 10.
Insert Soft Wire or Pull Wire Out of Terminal
Block
Figure 11.
Remove Jumper from Terminal Block
Connections
An 18-pin removable terminal block (the green part in Figures 9-11)
comes with the controller. The terminal block allows quick and easy
wiring. The terminal block can fit the wire from AWG 24 to AWG 16.
General Instructions for Terminal Attachment
•
To connect a hard wire to the terminal block
(such as
the footswitch terminals): Plug the end of the wire into the
terminal (Figure 9).
•
To connect a soft wire to the terminal block or pull out
the wire from the terminal block
: Use a flat screwdriver
to push the orange tab located beside the terminal. Then
plug the wire in or pull the wire out (Figure 10).
•
To remove the jumper from the terminal block
: Use two
flat screw drivers to simultaneously push the orange tabs
located beside the terminal. Then pull the jumper out.
(Figure 11)
