Page 4
Rev. 2
Airwalker Setup
The Airwalker Adjustable Hanging Strap requires
either a Quick Link or a Safety Snap (Climbing
Carabiner,18 kN minimum rating) to connect to the
Eyebolt. This provides a simple method to remove
the Airwalker for storage when not is use, and
protects the webbing strap from abrasion if looped
directly through the rough surface of the forged
eyebolt. Always check to make sure the Quick
Link nut is tight or the gate on the carabiner is
closed properly before using!
Install a
5
⁄
16
” or ⅜” Quick Link, or a Safety Snap
between the eyebolt and the hanging loop as shown
at right. Then thread the end of the Adjustable
Hanging Strap though the top opening of the
Airwalker rotator, and then up through the
bottom
of the clamp while depressing the release lever.
IMPORTANT:
The clamp will not hold the
strap if it is inserted from the top side.
Always test and make sure the clamp is
holding properly before using!
22 kN
Carabiner
Press down
Strap goes in bottom first
Pull strap out top to adjust
5
/
16
”
Quick
Link
