FS45B/45BT
13
to the diagram method;
3
）
middle or both ends of squeegee are not good performance in suction water.Rule out method:
adjust knob according to photo.
4
）
no reaction when turn on for brush or suction motor
troubleshooting method: after the switch is turned on, if the corresponding indicator light is
on the panel.
If the indicator light is on, check whether the fuse - > relay - > - related cable is loose or
damaged;
If the indicator light is not bright, it may be the main control circuit board due to water
damage;
5
）
suction motor can not be closed, even the key is closed, suction motor still running.
Rule out method: observe the panel indicator, if close the water absorption switch, water
indicator light off, the suction motor is still rotating, it is possible that the relay of suction
motor is damaged. If close water absorption switch, water indicator light still on, it is
possible that the main control circuit board damage.
6
）
water absorption effect is not good.
methods: to observe the state of suction of squeegee, and choose different methods to
adjust the squeegee.
When the machine is in the process of
feeling in the feel, with this knob to
adjust, until the feel is appropriate.
Method see note 8) 10 pages
loosen the lock nut adjusting screw,
observe the change of squeegee, until the
squeegee uniform contact with floor, then
lock nut.
the commissioning of the machine has been completed in the factory, the
general situation, the non professionals do not change its position!
Summary of Contents for FS45B
Page 19: ...FS45B 45BT 18 ...
