755066-100 Rev. C (6/17)
- 7 -
3
4
5
6
7
• The tail piece assembly, consisting of tail piece, drain strainer
gasket and slip-joint nut is used to connect the tub drain to
the drain/waste outlet. See
Fig. 4.
• Slide the slip-joint nut over tail piece towards the flanged end as shown.
• Slide the P-trap slip-joint nut and seal over the tail piece as shown.
• Assemble tail piece and P-trap. Cut tail piece if necessary.
For reference the flange of the tail piece should be approximately
2-1/2" (64 mm) above the finished floor when fully inserted
into the P-trap.
• Apply a generous bead of tub adhesive
to the base of the tub and leveling feet.
See
Photo 5.
FOR THE FREESTANDING TUB WITH FEET,
ONLY THE LEVELING FEET NEED TO HAVE
TUB ADHESIVE APPLIED.
• Carefully set the tub into position. Ensure that drain strainer gasket is fully seated against
the tail piece flange.
• Connect the tailpiece to the tub drain. Tighten all of the drain connections. Remove any
excess caulking where the tub meets the floor and allow the adhesive to cure for 24 hours.
Note: Connecting the tailpiece assembly and the drain will require access from
beneath the tub.
• For the Freestanding tub with feet, install lag screws thru the leveling feet into the holes drilled in the floor in step # 1.
• Fill the tub with water and drain. Check for leaks and re-tighten connections as necessary.
• For the Freestanding tub with base, apply a bead of Tub & Tile caulk around the bottom edge of the tub where it meets the floor.
• Remove any excess caulking.
• For the Freestanding Tub with Feet, apply a bead of silicone to the bottom of the decorative feet & install them on the tub
in the locations shown in
Fig 3
.
• Apply a bead of silicone to the foot covers and attach them to the feet.
• Remove any excess caulking.
INSTALLING THE 1-1/2" DIAMETER TAIL PIECE ASSEMBLY INTO P-TRAP
DRAIN STRAINER GASKET
SLIP-JOINT NUT
TAIL PIECE
P-TRAP
(PROVIDED BY
INSTALLER)
THREADED PORTION
OF DRAIN ADAPTER
TAIL PIECE
ASSEMBLY
2"
(51 mm)
FINISHED
FLOOR
P-TRAP
SLIP-JOINT NUT
& SEAL
(PROVIDED BY
INSTALLER)
Fig. 4.
Photo 5.
