- 4 -
- 4 -
1
2
NOTE:
Provide adequate floor support. The tub is heavy. Obtain sufficient help and use
suction cups/lifting straps to carefully lift or move tub.
• Make sure the factory-installed drain connections
to the tub have not become loose during shipping.
Tighten as needed to prevent leakage.
• Carefully place the tub on the finished level floor
in the desired location and over the drain/waste outlet.
(Fig. A)
• Mark the desired tub position or location on the floor with
an erasable marker, then remove the tub from the floor and
drain/waste outlet.
• Place template over drain/waste outlet (keeping centered
within the tubs marked area) and mark floor where 2 tub
anchors will be installed in floor, then drill marked floor
locations (approx. 2 3/4" (70 mm))
(Fig. B)
• Place inserts into drilled floor followed by screwing
in the tub anchors.
(Fig. C)
• Carefully place tub back on the finished floor,
over the drain/waste outlet and tub anchors.
(Fig. D)
• Check to ensure the tub is level in several directions.
Adjustable feet under the tub can be used to further
level the tub. Also check that there is a slight gap
between the tub base and the floor. Gap shall not
exceed 1/8" (3 mm).
NOTE:
The drain/waste outlet must be installed in accordance
with all local building codes.
All drain connections must be made using
an access created beneath the tub.
INSTALLATION INSTRUCTIONS:
1/8" MAX
(3 mm)
FINISHED FLOOR
TUB ANCHORS
755493-100 Rev. 1.0 (7/18)
Fig. A
Fig. B
Fig. C
Fig. D
