- 2 -
Press firmly.
WAX RING
INSTALL CLOSET BOLTS
Install closet bolts in flange channel
and slide into place parallel to wall.
TIP:
Place 2 pieces of masking tape
on floor (as shown) to help with
alignment in step 4.
Apply weight evenly. Do not move
after placement. Water tight seal
may break.
7302363-100 Rev. A (5/18)
1
4
2
5
3
!
WARNING:
Overtightening of water supply
line nuts could result in breakage
and potential flooding. If the
connection leaks after hand
tightening, replace the supply
line. Do not use any type of
sealant on the water supply
connection.
Use of plumber’s putty,
pipe dope, or any other
type of sealant will void
the warranty.
For seat installation,
see instructions
included with seat.
*
!
CLOSET BOLT
WASHER
NUT
CLOSET FLANGE
DRAIN
CENTER LINE
CLOSET BOLTS
6
CAUTION:
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
!
RUBBER
GASKET
TANK MTG.
BOLTS
WASHER/NUT
RUBBER
GROMMET
INSTALL TANK
a.
Insert rubber grommets through holes in the tank then
insert bolts through holes in the grommets.
b.
Install large rubber gasket over threaded outlet on
bottom of tank and lower tank onto bowl so that
tapered end of gasket fits evenly into bowl water
inlet opening.
c.
With tank parallel to wall, alternately tighten nuts until
tank is snugged down evenly against bowl surface.
